Are you aware when is the proper time to replace your water softener resin?
Here are some factors for you to know when considering water softener resin replacement:
It is essential to replace your resins mainly because they have been damaged through many years of exposure to chlorinated water. Take in mind that after roughly a decade, at times it could be earlier or later than this period; the resins usually swell and then this lead to break down. From there, you will notice that they become fragmented and you will see that the fines accumulating at the bottom distributor begin to inhibit the water pressure through the resin tank.
Indeed, they will begin coming into your dwelling place and will result to clogging the faucet screens – fragments will be observed on a few systems. Note that if resin fragments have been penetrating into your dwelling place, then this surely implies that it is high time to replace the bottom distributor.
More than that check out when the resin bed has become contaminated by an evident and usually distinguishable amount of algae growth- it is vital to understand that this issue is typical in tanks that are set up outdoors.
It is time to replace the resin tank if it already has a huge amount of fine sand inside it. In point of fact, this could take place on well water at times. This is the reason why it is highly suggested to invest on sediment pre-filter that is set up in the water line before your water softener.
The fine sand found in the resin bed can cause a very deficient water pressure. Furthermore, the sole technique to solve such issue is to suck out or dump all the sand or resins. In truth, replacing with new resins is more effective and a lot more effortless as compared to attempting to getting rid of the sand from your old resin.
Apart from all these, please be guided that when a resin tank has been unused for several months or even years and you can already spot or smell a foul odor- do not waste time and consider replacing it the soonest. You can try tidying it with a little amount of chlorine solution. However, be careful as you need to clear away the resins, thoroughly bleach the tank with the aid of a strong chlorine solution and from there you can possibly begin with fresh new resins.
If you are having problems with resins that are fouled by organics or iron, then you can try tidying them through the aid of adding a strong amount of resin cleaners like bleach, citric acid, iron out or ResUp. Alternatively, replacing with new works every now and then can work wonderfully as well.
What to remember when tidying your water resin?
You can tidy the inside of the tank with the help of bleach or chlorine if you think and feel that you need it. You may consider using a neat toilet bowl brush that comes with a piece of pipe so it can easily extend the handle- this is especially useful when you need to scrub the inside of the tank.
On the other hand, if you think it is necessary to replace the center pipe and the bottom distributor, see to it that the tank is empty.
Here are some helpful techniques when replacing resins in water softeners:
- First, make sure that the water is turned off.
- Next, disconnect the plumbing.
- From there, you may begin unscrewing the control head.
- Then, you need to carefully lay softener tank over the trash can or on side.
- Afterward, it is high time to insert the garden hose.
- Then, let the water to rinse out the old resin.
- Get rid of the old resin.
- Save the old gravel.
- Stand the tank in an upright position.
- Put the tape over the opening that is found in the product tube.
- From there, you can refill the gravel so that it will totally cover the screen.
- Then, pour in the fresh new resin till the tank is lightly a half full.
- Get rid of the tape on the product tube.
- Then, carefully re-attach the control head and reconnect the plumbing.
- You can now turn the water on and place the system in manual regeneration.
- Finally, you can now examine the product waster for softness.